Identification The suspension model and serial number are stamped on an aluminum tag that is riveted to the driver HOW TO: AXLE SEAL REPLACEMENT ON 1 TON FULL FLOATING REAR AXLE - Duration: 2 ... 2008-2016 DODGE RAM 4500 5500 LOCKING HUBS AND REPLACEABLE PARTS, BY THERAMMANINC.COM - Duration: 2:00. Chassis Torque Specs (4th Gen RAM) ... Axle Nut - 132 ft lbs Beginning Torque, Then Rotate 5 to 10 ~ Times With a Final Torque of 263 ft lbs Track Bar to Frame (2500/3500 4x4) -----200 ft lbs Track Bar to Axle (2500/3500 4x4) -----200 ft lbs Tie Rod End Nut -----55 ft lbs ABS Assembly Mounting Bolts -----11 ft lbs ABS Assembly ABM Screws -----31 in lbs ABS Assembly Brake Line … lbs.). Align nut to next cotter pin hole and install new cotter pin. I read about the driving thing if you had 2 people. Install axle washer and nut. 8.

Make sure to check out each part so …
Dodge 4500/5500 SuperDuty Cab Chassis RD1350D 11.88” 3.00” 3.00” Ride height is measured from the axle center (flat and level) to the bottom of the vehicle frame at the rear of vehicle, behind the axle as shown. 6. I used my floor jack and the cheater bar to brake the nut loose. Went to 250 then and xtra grunt with the cheater bar and the lines rematched perfect. 9.

Tighten axle nut to final torque of 356 Nm (263 ft. Mine was 1 11/16 and I remember the torque about 263 ft lb. Rotate axle several 5 to 10 times to seat the wheel bearing. My 1/2 only went to 250, but I marked the nut and axle w/nail polish. Welcome to the 3 part video series on replacing the rear brake rotors on the Ram 4500-5500 series of trucks.

*Forthe%most%uptodate%specifications,%visit%rambodybuilder.com Ram 3500/4500/5500 Chassis Cab Specifications 4x2 4x4 4x2 4x4 4x2 4x4 4x2 4x4 4x2 4x4 4x2 4x4 Tighten axle nut to 179 Nm (132 ft.

7.
lbs.).