Send: When the light is flashing, the modem is scanning for the send channel connection. The power light will be red when the modem is powered on. Your router is ready.

it will reboot and power on with all indicators light up, but after 5 seconds all the lights on front go out and only the power light remains lit.

There is a wiring misconfiguration. All this from switching off modem and nbn box for 5 minutes.. Not all CenturyLink modems show a red power light during boot-up. Solid amber. Power — the power light simply lets you know that the modem or router is plugged into a power source. Power light : red or amber: The unit has discovered a problem.

While the power light is red the modem is performing a hardware test.

Solid green or white. When working properly, your power light should display a steady light. Suggestions: Power-cycle your router by unplugging it, waiting 30 seconds, and plugging it back in. If the modem hardware test fails the power light will stay red. Power LED Off. A solid light indicates the channel connection is acquired. The LEDs on your router indicate the status of the connection between your router and the devices that are connected to it. ... Only 'Power' light is on the modem If you only have a power light, then most likely the modem … If you are experiencing this condition, first check for a service interruption by: Re: HT2000W Red Power Light, White System and White Receive lights I can get you a tracking number once it is loaded into our system (after UPS sends that info to us). Receive: When the light is flashing the modem is scanning for a receive channel connection. Hmm. The modem is defective. Typical reasons for this are: There is a service outage.

Or the light indicating the router’s connection to your DSL or cable modem just keeps blinking, and blinking, and … . The gateway is using battery power. Ethernet: Green: A computer or other device is connected to an Ethernet port. Flashing amber: The battery power is low. If the cable modem has been moved to a different outlet please contact customer service to relocate the modem. Your router is powering on. Not all CenturyLink modems show a red power light during boot-up. Starting to think it’s faulty now. No Connectivity, only power on, nothing else lights up I have lost all connectivity to my HT200W modem. Continuously flashing or blinking US/DS lights indicate that the modem is unable to establish a connection due to poor or no signal. While the power light is red the modem is performing a hardware test. Power light : steady green: If it is unlit, there is a power problem or the unit is broken. Power: A solid light indicates the modem is powered on. SEND light is off or flashing: Try to reset the modem by unplugging the power cord from the modem and wait 1 to 2 minutes. Try to reset the modem by unplugging the power cord from the modem and wait 1 to 2 minutes. Off: No battery is installed, or the battery isn’t charged.

They also indicate the status of your Internet, Wi-Fi, Ethernet, and WPS connections. I have no Internet but cable is up and running. I have rebooted it many times with same result. I tried the unplugging procedure and didn't work either.